Lucent Technologies P550 - Manual (Page 132)

Configuring IP Routing (Layer 3)
7-6 Cajun P550/P220 Switch Operation Guide
4. Use Table 7-3 to complete the configuration of your IP interface:
Table 7-3. IP Interfaces
Parameter Allows you to...
Select Select the interface to configure.
State Shows the current running condition of the switch. Options
include:
• UP - The interface is active.
• DOWN - The interface is inactive.
Interface Enter an interface name from the interfaces you have
previously configured.
Admin State Shows the administration state of the interface. The default
setting is UP. Options include:
• UP - Indicates an active state.
• DOWN - Indicates an inactive state.
VLAN Select a VLAN associated with the selected interface from the
VLANs you have previously configured.
Network Address Assign an IP address to the VLAN you previously selected.
Mask Assign a subnet mask for the interface.
MAC Format Specify the MAC format (Ethernet V2 or SNAP).
IP Routing Enable or disable IP Routing on the interface. When set to
Routing/Mgmt, you can both manage the switch (from the
CLI or Web Agent), and configure IP Routing for the switch.
When set to Mgmt Only, you can manage the switch,
however, IP routing is disabled.
Note: When the interface has a VLAN identified as
Serial-Console, the only valid IP routing
option is Mgmt Only.
RIP Enable or disable RIP for a given interface.
OSPF Enable or disable OSPF for a given interface.
Multicast Protocol Select a multicast protocol to associate with your interface.
Selections include: DVMRP, IGMP, and None. IGMP is
enabled automatically when DVMRP is selected.
Proxy ARP Enable or disable Proxy ARP on a given interface.
ICMP Redirect Enable or disable ICMP Redirect on a given interface.