Lucent Technologies P550 - Manual (Page 47)

Cajun P550/P220 Switch Operation Guide 3-1
3
Configuring the Cajun P550
Switch (Layer 2 & Layer 3)
This chapter and its procedures are common to both Layer 2 and Layer 3 configuration.
Included in this chapter:
❒ Terminal Settings
❒ Configuring the Supervisor Module Using the CLI
❒ Configuring the Switch Using the Web Agent
❒ Configuring Port Parameters Using the Web Agent
❒ Configuring System Information
❒ Managing Configuration Files
Terminal Settings
To complete initial switch setup, you need a PC with a serial line connection. It must
have the following terminal settings to communicate with the switch (Table 3-1).
Configuring the Supervisor Module Using the CLI
To connect to the Web Agent, you must first use the serial command line interface (CLI)
to give the supervisor module an IP address and a subnetwork mask.
Table 3-1. Terminal Settings
Baud Rate Stop Bits Data Bits
Flow
Control
Parity
9,600 1 8 Xon/Xoff None