Lucent Technologies P550 - Manual (Page 189)

Configuring the OSPF Routing Protocol (Layer 3)
Cajun P550/P220 Switch Operation Guide 9-7
Modifying OSPF Virtual Links
To modify an OSPF virtual link:
1. In the OSPF Configuration section of the Web Agent window, click Virtual
Links. The OSPF Virtual Links dialog box opens.
2. Select the virtual link to be removed.
3. Use Table 9-4 to modify your configuration.
4. Click APPLY to save your changes, or CANCEL to restore previous settings.
Creating OSPF Summaries
The primary purpose of the OSPF summary is route aggregation. Route aggregation is a
group range of IP addresses that are linked to a single address.
To create a new OSPF summary:
1. In the OSPF Configuration section of the Web Agent window, click Summaries.
The OSPF Summaries dialog box opens.
2. Click CREATE to create a new OSPF summary.
Note: This window will only appear with configured OSPF summaries if you have
previously configured one or more OSPF summaries.
3. Use Table 9-5 to configure your OSPF summaries:
4. Click CREATE to save your changes, or CANCEL to restore previous settings.
Table 9-5. OSPF Summaries Parameters
Parameter Definition
Area Select the area ID of the area from which the routes are
aggregated (summary IP address).
Network Address Enter the IP address of the network to be advertised.
Mask Enter the subnet mask of the network to be advertised.
Advertisement Select the ability to suppress (disable) or enable advertisements
of this summary. When suppressing, advertisements of IP routes
in this range are also suppressed.