Lucent Technologies P550 - Manual (Page 201)

Configuring AppleTalk Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide 10-3
Creating an AppleTalk Routing Interface
To create an AppleTalk interface:
1. Enable AppleTalk routing globally. Refer to “Enabling AppleTalk Global Routing”,
earlier in this section.
2. In the AppleTalk Configuration section of the Web Agent window, click
Interfaces. The AppleTalk Interfaces dialog box opens.
3. Click CREATE. The Add AppleTalk Interfaces dialog box opens.
4. Use Table 10-1 to configure your AppleTalk interface.
Table 10-1. AppleTalk Interface Parameters
Parameter Definition
Interface Enter the name of the AppleTalk interface to be created.
VLAN Select the VLAN to be associated with the AppleTalk
interface.
Options include:
• Default
• Discard
• All created VLANs
Metric Enter the metric associated with the AppleTalk interface.
Encapsulation Type Select the encapsulation type to be associated with the
AppleTalk interface.
Options include:
• Ethernet II - MTU = 1500
• Ethernet SNAP - MTU =1492
Network Range Start Enter the starting network number. The network number
specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 0 and 65279.
Note: The Network Range Start value must be less
than or equal to the Network Range End
value.
Network Range End Enter the ending network number. The network number
specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 0 and 65279.
Note: If the Network Range Start value equals 0,
Network Range End value must also equal
0.