Sierra Wireless 20070914 - Manual (Page 78)

Data Communication and Host Modes
Rev 3.0B Feb.08 65
Figure 8-4: AceManager : Other - *TPORT, *TELNETTIMEOUT.
Serial Modes
PPP
In PPP mode, the PinPoint X acts as a PPP server, providing an
IP address, and DNS servers (if available) to the connected
device or computer.
PPP mode is entered from the AT mode by using any of the
following commands:
• AT\APPP
• ATDT10.0.0.1
• ATDT10001
• ATD#19788 or #777 *99***1#
• CLIENT
In response to any of the preceding commands, the PinPoint X
will respond with CONNECT a carriage return and new line
and is ready for the host to begin PPP negotiations. The IP
received by the host in the resulting negotiation will either be a
private (non‐routable) IP address or a public (network‐
routable) IP address provided by the network, depending on
the settings of *HOSTPRIVMODE. If *HOSTPRIVMODE=1,
the value of the private IP address can be determined
beforehand by querying S110. The private IP address to be
used can be defined with the command
AT*HOSTPRIVIP=192.168.100.33, substituting the desired IP
address.