Sierra Wireless 20070914 - Manual (Page 138)

Configuration Commands
Rev 3.0B Feb.08 125
• hh:mm:ss=time in 24‐hour notation
*DPORT=n
The modemʹs Device Port which the modem is listening on for
inbound packets/data/polls. Can also be set with the command
S110.
• n=1‐65535
*HOSTPAP=n
Use PAP to request the user login and password during PPP
negotiation on the host connection.
• n=0 : Disable PAP request (Default).
• n=1 : Takes user login and password from Windows DUN
connection and copies to *NETUID and *NETPW.
*NETALLOWZEROIP=n
Allows the displayed IP address in *NETIP to end in zero (ex.
192.168.1.0).
• n=0 : Do not allow.
• n=1 : Allow.
*NETPW=pw
The password that is used to login to the cellular network,
when required.
• pw=password (30 characters maximum)
*NETPHONE?
The modem’s phone number, if applicable or obtainable.
•
*NETUID=uid
The login that is used to login to the cellular network, when
required.
• uid=user id (up to 64 bytes)
*STATICIP=d.d.d.d
Set the static IP required to be received from the network. If the
modem does not get this IP address from the network, it will
reset the internal hardware and try again. The default is 0.0.0.0,
which allows any IP address from the network.
• d.d.d.d=IP address
Example:
AT*STATICIP=192.168.1.23