Sierra Wireless 20070914 - Manual (Page 139)

Configuration Commands
Rev 3.0B Feb.08 126
Caution: STATICIP does not set the IP address of the modem, it
merely tells the modem which IP address to expect. If the expected IP
address is not granted while registering on the cellular network, the
modem will try to register on the network again until it receives that IP
address. If your account is set up for a dynamic IP address and you
set an address for *STATICIP, you may not be able to register on the
network at all since there is no guarantee you will receive the same
dynamic IP address again.
*STATUSCHK=n
Checks if an SMS message has been received by the modem.
• n=1‐255 : Seconds between checks.
• n=0 : Never check.
USB
The PinPoint X is enhanced to with a USB port for additional
connection options.
Figure 1-6: AceManager: USB
*USBDEVICE=n
This command configures the behavior of the USB port. For
both modes, a driver supplied by AirLink will need to be
installed to use the port accordingly.
• n=0 : Port can be used as a virtual serial port.
• n=1 : Port can be used as a virtual Ethernet port.
Serial
This group includes commands specific to general use of the
serial port.