Sierra Wireless 20070914 - Manual (Page 146)

Configuration Commands
Rev 3.0B Feb.08 133
*ENQ=n
Outputs an ENQ [0x05] after the TCP CONNECT delayed by
the Delay Connect Response time (S221).
• n=0 : Disabled (Default).
• n=1 : Enable ENQ on CONNECT.
UDP
This group includes commands specific to UDP serial commu‐
nications.
Figure 1-9: AceManager : UDP
AIP=n
Allow IP address.
• n=0 : Allow only the IP address specified in S53 to connect
when UDP auto answer is enabled (S82=2).
• n=1 : Allow any incoming IP address to connect when
UDP auto answer is enabled (S82=2).
Note: Always subject to any Friends filters that may be defined.
HOR=n
Half‐Open Response ‐ In UDP auto answer (half‐open) mode.
• n=0 : No response codes when UDP session is initiated.
• n=1 : RING CONNECT response codes sent out serial link
before the data from the first UDP packet.
Note: Quiet Mode must be Off.