Sierra Wireless 20070914 - Manual (Page 165)

Configuration Commands
Rev 3.0B Feb.08 152
#U
Immediately issue GPS report to the ATS server IP and port.
Not available in AceManager.
*PGPS=n
Send NMEA GPS strings out serial link. Similar to ATGPS
except that the *PGPS value can be saved to NVRAM so that it
will continue to operate after resets.
• n=0 : Disabled
• n=1 : Send NMEA GPS strings out serial link.
• n=2 : Send NMEA GPS strings out the USB port.
• n=3 : Send NMEA GPS strings out both the serial and the
USB port.
*PGPSF=n
Persistant GPS frequency
• n= number of seconds per report
Max Value: 65535 up to 18 hours
*PPCOM1000=n
Enables support for extra inputs from a COM1000.
• n=0 : Disable
• n=1 : Enable
Tip: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are
enabled, the PinPoint X digital inputs will be reported and the
COM1000 inputs will be ignored.
*PPDEVID=n
Whether or not the PinPoint X should include the 64‐bit device
ID in its GPS reports. *PPDEVID MUST be 1 if the modem uses
a Dynamic IP.
• n=0 : Disable ID.
• n=1 : Enable/display ID.
*PPDIST=n
GPS Report Distance Interval in 100 Meter Units (kilometer). 1
mile is approximately 1600 kilometers.
• n=0 : Disabled
• n=1‐65535