Sierra Wireless 20070914 - Manual (Page 133)

Configuration Commands
Rev 3.0B Feb.08 120
• Hardware Reset: The internal module is being reset. This
is a temporary state.
*POWERIN?
The voltage input to the internal hardware.
*POWERMODE?
Displays the current power state/mode. Possible values
returned are:
• Initial: The modem is in the initial 5 minutes since power
up, so power down event will be ignored.
• On: Regular power on, a power down is not pending.
• Low Cancellable: Power down is pending but still
cancelable if the power down trigger goes away.
• Low Pending 1 and Low Pending 2: Power down is
pending, any modem tasks are gracefully preparing for the
power down.
• Low Final: Power down is imminent.
• Low: Power is down.
Information Displayed in AceManager
without AT Commands Listed
• Bytes and Packets Received and Sent: Network traffic for
the applicable port.
• Number of System Resets: Counter of the number of
system resets over the life of the modem or since the
configuration was reset.
• Bad Password Count: Counter of the number of bad
password attempts.
• IP Reject Count or Log: Rejected IP Data.
• Temperature of the Internal Hardware Module: The
temperature of the internal radio module.
• GPS information: Number of satellites, GPS Fix (0 = No
Fix, 1 = GPS Fix, 2 = WAAS), latitude, and longitude.
GPS Status and Map Link
Note: The map feature will only
work if you have access to the
Internet on your computer either
through the modem or separate
from the modem. In AceManager, next to the displayed information of the
Latitude and Longitude, there is a link to an external map
which will visually place the co‐ordinates. When you click the
map link, it will open your default web browser with the map
location highlighted.