Sierra Wireless 20070914 - Manual (Page 135)

Configuration Commands
Rev 3.0B Feb.08 122
Misc (Miscellaneous)
The commands of the “Misc” group are a variety of commands
that don’t directly fit in other categories.
Figure 1-5: AceManager : Misc
+++
Note: +++ is not proceeded by
AT nor does it require a carriage
return (enter). There must be an
idle time (set by S50) on the
serial port before and after this
command. AT Escape sequence. If the PinPoint X is in a data mode (any
mode other than PassThru), this command causes the modem
to re‐enter AT command mode. The “+” is ASCII 0x2B.
+++ is
not available in AceManager.
Tip: DAE=1 disables the +++ command.
A/
Note: A/ is not proceeded by AT. Re‐execute last command. A/ is not used in AceManager.
A
Manually answer an incoming connection. A is not used in
AceManager.
D[method][d.d.d.d][/ppppp] or D[method][@name][/
ppppp]
Dial a connection to a remote IP and Port using method.
Cannot be configured in AceManager.
• method=P : Establish a UDP connection
• method=T : Establish a TCP connection
• method=N : Establish a Telnet connection