Sierra Wireless 20070914 - Manual (Page 170)

Configuration Commands
Rev 3.0B Feb.08 157
• n=0 : Disabled
• n=1‐65535 (default 9494)
*PPTIME=n
GPS Report Time Interval. See also *PPMINTIME, *PPTSV,
+CTA.
• n=seconds (1 ‐ 65535)
Note: Your cellular carrier may
impose a minimum transmit time. Caution: A report time of less than 30 seconds can possibly keep an
RF link up continuously. This will eventually cause the PinPoint X to
overheat and shutdown. An RF resource may continue be tied up to
transfer small amounts of data. Generally the RF channel will be
released and go dormant in 10-20 seconds of no data sent or
received.
*PPTSV=n
Timer for Stationary Vehicles. Time interval in minutes that the
PinPoint X will send in reports when it is stationary.
• n=0 : Disabled
• n=1‐255 minutes
For example, if *PPTIME=10, the PinPoint X will send in
reports at least every 10 seconds while it is moving; however,
once it stops moving, it will slow the reports down to this
*PPTSV value.
*UDPRGPS=n
Set or query GPS stamping of UDP Reliable packets. When set,
data received on the host serial port will be encapsulated with
the GPS date and time.
• n=0 : Disabled (default)
• n=1 : Enabled
I/O
This group includes configuration commands for the digital
and analog inputs and relay outputs. Some of the values
shown as a part of this group are not changeable but reflect the
current status.