Sierra Wireless 20070914 - Manual (Page 136)

Configuration Commands
Rev 3.0B Feb.08 123
• d.d.d.d= IP address to contact
• ppppp= port to contact
Examples:
ATD - Dial (establish) default connection.
ATDP192.168.13.31/2332 - Dial (establish) UDP session to
192.168.13.31, at port 2332.
To end the connection, issue the +++ escape sequence or drop
the DTR line (if Ignore DTR S211=0 or &D2). The default
connection is set in S53.
If the method, IP address, or port is omitted, the values from
S53 are used. If a telnet connection is requested (N) and the
port is not supplied, port 23 will be used instead of the value
from S53.
If a domain name is specified, the ʹ@ʹ symbol can be used to
explicitly indicate the start of the name. For example, if
ATDPHONY is issued, this will be interpreted as dial a UDP
connection to “HONY”. To dial using the default method to
host “PHONY”, one would issue ATD@PHONY.
Several special dialing numbers exist to make it easy to
establish a PPP or SLIP connection with the modem.
ATD#19788 or ATDT#19788 will establish a PPP connection
(see \APPP) and ATDT#7547 will establish a SLIP connection
(see \ASLIP).
Tip: The source port of the session is the Device Port (set by S110 or
*DPORT).
DS=n
Allows a PPP connection to be initiated on the host port.
• n=2 : Initiates the PPP connection.
Cannot be configured in AceManager.
Hn
Hang‐Up Command.
• n=1 : Hang‐up
With an AT telnet connection, this command will terminate the
host data mode and return the PinPoint X to an AT mode.
Cannot be accessed in AceManager.
O
Online (Remote): Causes the Raven to go from Command State
to data state. Cannot be configured in AceManager.