Sierra Wireless 20070914 - Manual (Page 154)

Configuration Commands
Rev 3.0B Feb.08 141
Note: It may take up to 30 seconds for the hardware module to
respond after CONNECT is output.
*CSX1=n
PassThru Echo : Echo data to the host.
• n=0 : Data will be passed to the host.
• n=1 : PASSTHRU mode will echo all host received data
and will not pass the data to the modem while the modem
is not asserting DCD.
Note: If the modem is asserting DCD, data will be passed from the
host to the modem as it normally is when *CSX1=0.
*PTINIT=string
Any AT Command string to be passed to the OEM module
before entering PASSTHRU mode, e.g. AT&S1V1, etc.
• string=AT command(s)
*PTREFRESH=n
Number of minutes of inactivity in PASSTHRU mode to
resend the *PTINIT string to the hardware module.
• n=0 : Disabled
• n=1‐255 minutes
*RESETPERIOD=n
In PASSTHRU mode, modem will be reset after this period if
no data has been sent or received. Value is in hours.
• n=0 : Disabled
• n=1‐255 hours
SMTP
SMTP (Simple Mail Transfer Protocol) is the de facto standard
for email transmission across the Internet. The PinPoint X can
send messages using SMTP if it has been configured to use a
mail server.
Note: You cannot send an Email with your PinPoint X unless the
Email server you have configured allows your PinPoint X as a relay
host. Talk to your network administrator to ensure you can send email
through the email server using your PinPoint X.