Sierra Wireless 20070914 - Manual (Page 168)

Configuration Commands
Rev 3.0B Feb.08 155
*PPMINTIME=n
Specifies the minimum amount of time between reports
generated due to either the time interval (*PPTIME) or the
distance interval (*PPDIST). This is useful to limit network
traffic and make more efficient use of bandwidth. This can be
used in conjunction with store and forward. The minimum
value which this setting can take depends on the policies of the
carrier.
• n=0 : Disabled
• n=1‐65535 seconds
*PPODOM=n
Enable odometer reporting.
• n=0 : Disabled (default)
• n=1 : Enabled
*PPODOMVAL=n
The current odometer value of the PinPoint X. The value is in
meters. Maximum value is approximately 4.3 billion meters
(2.5 million miles). 1 mile is approximately 1600 meters.
• n=meters
*PPPORT=n
Port where GPS reports are sent.
• n=1‐65535
*PPREPORTINPUTS=n
Enable input reporting.
• n=0 : Disabled
• n=1 : Enabled
Note: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are
enabled, the PinPoint X digital inputs will be reported and the
COM1000 inputs will be ignored.
*PPSIMPLETO=n
Defines the linear back‐off base number. Not available in
AceManager.
• n=0 : Disabled
• n=5‐255