Siemens Commissioning PC Stations C79000-G8976-C156-07 - Manual (Page 53)

4 Using Additional Functions - Special Features to Note
53
Commissioning PC Stations - Manual and Quick Start
Release 5/2005
C79000-G8976-C156-07
You can check the selected module with the “Configuration Console” program
using the “Access points” function:
S
fixed access point SIMOTION CP_SM_1: e.g. CP_SM_1: - >
CP5613(PROFIBUS)
S
fixed access point PROFINET CP_PN_1: e.g. CP_PN_1: - >
CP1613(RFC1006)
For further information on PROFINET and SIMOTION, please refer to the
documentation of the PROFINET iMap or SIMOTION Scout engineering programs.
4.3.2 Configuring Access Points for STEP 7 and STEP 5
How Access Points are used
Many user programs require an “access point” to be specified to allow an
assignment to the communication module.
The access point is a symbolic name with which the user program can access the
assigned communication interface / module.
Applications that handle communication over connections configured in the project
engineering do not require the access points described here.
For example, for local PG operation, STEP 7 works with the access point
“S7ONLINE“, and STEP 5 uses the access point “CP_H1_1:” for Industrial
Ethernet and the access point “CP_L2_1:” for PROFIBUS.
By reconfiguring an access point, you can for example, control the interface over
which STEP 7 communicates.
Tools
In the description of the steps “Configuration for PG operation - programming
device (PG/PC) / HMI stations”, we showed you how to specify and assign access
points using the Set PG/PC Interface tool.
The following section describes how you can manage access points with the
“Configuration Console” tool (see also “Tools”).
Viewing and Setting Access Points
Follow the steps outlined below to display the existing access points (Steps 1 and
2) and to create a new access point (Steps 3 and 4):