Trouble check, Camcorder – Sony CCD TR 502 E User Manual
Page 65
CCD-TR501E/TR502E/TR620E 3-859-127-13.E/R
65
Additional information
СУФУОМЛЪВО¸М‡fl ЛМЩУ
П‡ˆËfl
If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.
Camcorder
Power
Symptom
Cause and/or Corrective Actions
• The battery pack is not installed.
m
Attach the battery pack firmly by pushing the lower part of
the battery pack until it clicks twice. (p. 10)
• The battery is dead.
m
Use a charged battery pack. (p. 7)
• The AC power adaptor is not connected to mains.
m
Connect the AC power adaptor to mains. (p. 23)
• While being operated in CAMERA mode, the camcorder has
been in the Standby mode for more than 5 minutes.
m
Turn STANDBY down once and turn it up again. (p. 12)
• The battery is dead.
m
Use a charged battery pack. (p. 7)
• The ambient temperature is too low. (p. 53)
• The battery pack has not been charged fully.
m
Charge the battery pack again. (p. 7)
• The battery pack is completely dead, and cannot be recharged.
m
Use another battery pack. (p. 22)
Operation
Symptom
Cause and/or Corrective Actions
• The tape is stuck to the drum.
m
Eject the cassette. (p. 11)
• The tape has run out.
m
Rewind the tape or use a new one. (p. 20)
• The POWER switch is set to PLAYER.
m
Set it to CAMERA. (p. 12)
• The tab on the cassette is out (red).
m
Use a new cassette or slide the tab. (p. 11)
• The battery is dead.
m
Use a charged battery pack or the AC power adaptor.
(p. 7, 23)
• Moisture condensation has occurred.
m
Remove the cassette and leave the camcorder for at least
1 hour. (p. 58)
• The POWER switch is set to CAMERA or OFF.
m
Set it to PLAYER. (p. 20)
• The tape has run out.
m
Rewind the tape or use a new one. (p. 20)
The battery pack is quickly
discharged.
START/STOP does not operate.
The cassette cannot be removed.
No function except for cassette
ejection works.
The tape does not move when a
tape transport button is pressed.
English
Trouble check
The power goes off.
The power is not on.
Continued to the next page