IBM Oce TDS800 - Manual (Page 90)

90 Océ TDS800 User Manual
from the local controller via File Transfer Protocol (FTP) (see Figure 40). Also
if during scanning to a remote destination, something goes wrong, you can
retrieve your files from the local controller.
Files scanned to a local destination are stored in the directory of the controller.
You can retrieve your files from the local host via File Transfer Protocol (FTP).
FTP can be done:
1 via an internet browser
2 an FTP application, or
3 via a command line prompt.
[40] How to retrieve scan files
▼ Retrieve files via an FTP command line promp t
1 Launch an FTP client.
2 Enter the ‘ftp’ command.
A DOS box now appears with the FTP prompt.
3 Enter the ‘Open’ command followed by either the registered name of the Océ
Power Logic® Controller or the IP address (for example: 194.2.66.146) to
connect to the Controller and press Enter: ‘open 194.2.66.146’.
Note: Instead of performing steps 2 and 3 you could also enter “ftp
host_name” in the FTP client.
The connection with the Controller is now established and a window appears
asking you for a user name.