IBM Oce TDS800 - Manual (Page 194)

194 Océ TDS800 User Manual
Add the toner
If the toner is empty the display shows: ‘Out of toner’ (see Figure 99). You can
add toner even while you print a job. You can finish your current job.
Note: If you do not add toner in time, the system will stop.
[99] ‘Out of toner’ message
▼ How to add toner
1 Shake the toner bottle.
2 Loosen the cap.
3 Open the front top cover.
Note: Only use E1 toner.
4 Open the toner refill opening.
Note: Do not remove the seal of the bottle opening.
5 Put the bottle with the ridge into the notch of the fill opening and push it down
(see Figure 100).
[100] Put the toner bottle into the fill opening
The seal at the bottle opening is cut at the opening of the toner reservoir,
allowing the toner to get out of the wide bottle.