IBM Oce TDS800 - Manual (Page 179)

The folder 179
Folder
The Océ TDS800 can have a folder to fold your output. The output is folded
according to the selected folding width and length with the drawing method.
Set the drawing method in the Océ Settings Editor (see ‘Find system settings
in the Settings Editor’ on page 139).
Note: You can only fold paper. Polyester, transparent or vellum media cannot
be folded. If you try to fold polyester, transparent or vellum media, a media jam
will occur.
Standard folding settings By default, you use the standard folding settings
defined for your Océ TDS800 system by the key operator. The following
settings are available:
▼ Set the folded copy delivery
1 Press the ‘Finishing’ card in the ‘Print’ section.
2 Press the function key ‘Folded copy delivery’.
3 Select ‘Stacker’ or ‘Belt’.
▼ Set folding legend
1 Press the ‘Feeding’ card in the ‘Original’ section.
2 Press the function key ‘Legend location’.
3 Select ‘Leading’ or ‘Trailing’.
Note: In the drivers this setting is called the ‘Folding orientation’, with the
options ‘Portrait’, ‘Landscape’ and ‘Automatic’.
▼ Set the drawing method
1 Press the ‘Feeding’ card in the ‘Original’ section.
2 Press the function key ‘Drawing method’.
3 Select ‘Standard’, ‘Ericsson’ or ‘Afnor’.
▼ Set the folded package width
1 Press the ‘Finishing’ card in the ‘Print’ section.
2 Press the function key ‘Folded package’.
3 Select ‘Width’.
4 Enter a range between 186 - 230 mm or 7.3 - 9 inch, in steps of 1 mm or 0.1
inch; default 210 mm or 9 inch.