IBM Oce TDS800 - Manual (Page 223)

Problem solving 223
If you can not correct the problem, you can open the output transport unit and
remove the paper (see Figure 136 on page 223). If the fuser-section covers
remain to flash on the display, check the fuser section again.
[136] Open the transport output unit
Paper jam in the paper roll compartments
▼ How to clear a paper jam in the paper roll compartments
Note: Make sure that you corrected all the problems in the fuser section,
before you correct the problem in the roll feed section.
1 Completely open the correct paper roll compartment.
2 Remove any jammed paper:
■ Behind the chip tray
■
Underneath the plate
■ Underneath the roll 2, the roll 4 or the roll 6 feed plate
3 Reload the roll if necessary.
4 Close the paper roll compartment.