IBM Oce TDS800 - Manual (Page 190)

190 Océ TDS800 User Manual
7 Use both hands to put the holder in the paper roll compartment. First, position
the left hand side of the holder in its notch, then position the right hand side in
its notch (see Figure 94).
[94] Put the roll into the paper roll compartment
8 If the new roll does not have a straight leading strip you can cut it manually.
9 Press the correct button inside the paper roll compartment and feed the paper
between the input guide plates as indicated by the arrow (see Figure 95). The
material is fed into the machine.
Note: Also see the stickers inside the roll compartments on how to feed
paper.
[95] Button to feed the paper
10 Close the paper roll compartment. The material is cut. The size of material is
indicated on the operator panel.
Note: If you have loaded another media type, you have to define the type
(see ‘Define the media type’ on page 192).