IBM Oce TDS800 - Manual (Page 181)

The folder 181
[84] Fold options from the scanner operator panel
3 Open the ‘Finishing’ card in the ‘Print’ section.
4 Press the ‘Folding’ function key to select ‘Full’ or ‘First fold only’ (see
Figure 85).
5 Press the ‘Folded package’ function key and change the length and/or width of
the folded package, as required, by using the arrow keys or the numeric keys.
6 If required, press the ‘Binding’ function key.
Set the required binding strip using the arrow keys or the numeric keys.
7 Make other settings as required.
8 Feed the original.
[85] Fold options from the scanner operator panel
You can also select a drawing method and, if needed, a folding length, folding
width and binding strip. When you change the folding length and/or folding
width, and the folder has a belt, you must also adjust the side guides of this
unit.