IBM Oce TDS800 - Manual (Page 198)

198 Océ TDS800 User Manual
3 Remove the trailing strip of the old tape (see Figure 105).
[105] Remove the trailing strip of the old tape.
4 Remove the screw of the front side plate of the roll holder with the green nut
and remove the old kernel.
Note: Clean the reinforcement knives before you put in a new roll
▼ How to insert a new tape roll
1 Put the new roll and close the side plate. Put the roll with the holes to the back
and the protection sheet to the front (see Figure 106).
[106] Put the new roll