IBM Oce TDS800 - Manual (Page 239)

Problem solving 239
3 Check if there are loose reinforcement strips in the unit with the protection
sheet still on(see Figure 163).
[163] Situation A: No mechanical error Situation B: Mechanical error
4 If yes, remove the tape strips in the Reinforcement Unit.
If the protection sheet is not on the reinforcement strip (see situation A in
figure 204), there is no mechanical error and you should insert a new tape roll
as described in ‘Inserting a new tape roll’ on page 143. If this error frequently
occurs you should call the Océ service organisation (see ‘Other problems (call
service)’ on page 184).
5 Remove all tape between the rollers and knives (see Figure 164)
[164] Remove the tape
6 Wire a new trailing strip of tape between the rollers and the knives ‘Change the
tape roll in the reinforcement unit’ on page 196.