IBM uPD78082 - Manual (Page 163)

140
CHAPTER 11 SERIAL INTERFACE CHANNEL 2
11.3 Serial Interface Channel 2 Control Registers
Serial interface channel 2 is controlled by the following four registers.
• Serial Operating Mode Register 2 (CSIM2)
• Asynchronous Serial Interface Mode Register (ASIM)
• Asynchronous Serial Interface Status Register (ASIS)
• Baud Rate Generator Control Register (BRGC)
(1) Serial operating mode register 2 (CSIM2)
This register is set when serial interface channel 2 is used in the 3-wire serial I/O mode.
CSIM2 is set with a 1-bit or 8-bit memory manipulation instruction.
RESET input sets CSIM2 to 00H.
Figure 11-3. Serial Operating Mode Register 2 Format
Cautions 1. Set 0 to the bits 0 and 3 to 6.
2. When UART mode is selected, CSIM2 should be set to 00H.
6 5 4 3 2 1 0 7
Symbol
CSIM2 CSIE2 0 0 0 0
CSIM
22
CSCK 0 FF72H 00H R/W
Address After Reset R/W
CSCK
0
1
Clock Selection in 3-wire Serial I/O Mode
Input clock from off-chip to SCK2 pin
Dedicated baud rate generator output
CSIM22
0
1
First Bit Specification
MSB
LSB
CSIE2
0
1
Operation Control in 3-wire Serial I/O Mode
Operation stopped
Operation enabled