5 basic device configuration, Basic device configuration -5, Basic device configuration – Motorola AP-51XX User Manual
Page 81
Getting Started
3-5
4.
Press
5.
Enter the default username of “
admin
” and the default password of “
motorola.
”
As this is the first time you are logging into the access point, you are prompted to enter a
new password and set the county code. Refer to
available countries two digit country code.
6.
At the CLI prompt (admin>), type “
summary
.”
The access point’s LAN IP address will display.
7.
Using a Web browser, use the access point’s IP address to access the access point.
8.
Refer to
Basic Device Configuration on page 3-5
for instructions on the initial (basic)
configuration of the access point.
3.5 Basic Device Configuration
For the basic setup described in this section, the Java-based Web UI will be used to configure the
access point. Use the access point’s LAN interface for establishing a link with the access point.
Configure the access point as a DHCP client. For optimal screen resolution, set your screen resolution
to 1024 x 768 pixels or greater.
1.
Log in using
admin
as the default Username and
motorola
as the default Password. Use
your new password if it has been updated from default.
There is no difference in the login method between the AP-5131 and AP-5181 model access
points. However, each model displays a login screen unique in appearance (with a different
model name). Additionally, each model access point displays a banner on top of each menu
screen unique to the AP-5131 or AP-5181 model supported.
NOTE
For optimum compatibility, use Sun Microsystems’ JRE 1.5 or higher
(available from Sun’s Website), and be sure to disable Microsoft’s Java
Virtual Machine if installed.