Motorola AP-51XX User Manual
Page 305
Monitoring Statistics
7-7
3.
Refer to the
Received
field to view data received over the access point LAN port.
Status
Displays whether this particular LAN has been enabled as viable
subnet from within the LAN Configuration screen.
IP Address
The Internet Protocol (IP) addresses for the access point LAN port.
Network Mask
The first two sets of numbers specify the network domain, the next
set specifies the subset of hosts within a larger network. These
values help divide a network into subnetworks and simplify routing
and data transmission.
Ethernet Address
The Media Access Control (MAC) address of the access point. The
MAC address is hard coded at the factory and cannot be changed.
For more information on how access point MAC addresses are
assigned, see
AP-51xx MAC Address Assignment on page 1-27
Link
The
Link
parameter displays
Up
if the LAN connection is active
between the access point and network, and
Down
if the LAN
connection is interrupted or lost. Use this information to assess the
current connection status of LAN 1 or LAN2.
Speed
The LAN 1 or LAN 2 connection speed is displayed in Megabits per
second (Mbps), for example, 54Mbps. If the throughput speed is
not achieved, examine the number of transmit and receive errors,
or consider increasing the supported data rate. To change the data
rate of the 802.11a or 802.11b/g radio, see
or 802.11b/g Radio on page 5-55
.
Duplex
Displays whether the current LAN connection is full or half duplex.
WLANs Mapped
The
WLANs Mapped
table lists the WLANs mapped to this LAN
(either LAN1 or LAN2) as their LAN interface.
RX Packets
RX packets are data packets received over the access point LAN
port. The number is a cumulative total since the LAN connection
was last enabled or the access point was last restarted. To begin a
new data collection, see
Configuring System Settings on page 4-2
.
RX Bytes
RX bytes are bytes of information received over the LAN port. The
value is a cumulative total since the LAN connection was last
enabled or the access point was last restarted. To begin a new data
collection, see
Configuring System Settings on page 4-2
.