Motorola AP-51XX - Manual (Page 130)

AP-51xx Access Point Product Reference Guide 4-38
3. Configure the Minimum Packets field to define a minimum packet throughput value for
trap generation.
4. Click Apply to save any changes to the SNMP RF Traps screen. Navigating away from the
screen without clicking the Apply button results in all changes to the screen being lost.
5. Click Undo Changes (if necessary) to undo any changes made. Undo Changes reverts the
settings displayed on SNMP RF Traps screen to the last saved configuration.
NOTE Average Bit Speed,% of Non-Unicast, Average Signal, Average Retries,%
Dropped and % Undecryptable are not access point statistics.
Pkts/s Enter a maximum threshold for the total throughput in Pps (Packets
per second).
Throughput Set a maximum threshold for the total throughput in Mbps
(Megabits per second).
Average Bit Speed Enter a minimum threshold for the average bit speed in Mbps
(Megabits per second).
Average Signal Enter a minimum threshold for the average signal strength in dBm
for each device.
Average Retries Set a maximum threshold for the average number of retries for
each device.
% Dropped Enter a maximum threshold for the total percentage of packets
dropped for each device. Dropped packets can be caused by poor
RF signal or interference on the channel.
% Undecryptable Define a maximum threshold for the total percentage of packets
undecryptable for each device. Undecryptable packets can be the
result of corrupt packets, bad CRC checks or incomplete packets.
Associated MUs Set a maximum threshold for the total number of MUs associated
with each device.
Minimum number of
packets required for a
trap to fire Enter the minimum number of packets that must pass through the
device before an SNMP rate trap is sent. Motorola recommends
using the default setting of 1000 as a minimum setting for the field.