Motorola AP-51XX - Manual (Page 505)

8-171
AP51xx>admin(system.snmp.access)> add
Description:
Adds SNMP access entries for specific v1v2 and v3 user definitions.
Syntax:
For information on configuring SNMP access settings using the applet (GUI), see Configuring SNMP Access Control on page 4-29 .
add acl Adds an entry to the SNMP access control list with as the starting IP address and
and as the ending IP address.
v1v2c
: comm - community string 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
v3
: user - username 1 to 31 characters
: access - read/write access - (ro,rw)
: oid - string 1 to 127 chars - E.g. 1.3.6.1
: sec - security - (none,auth,auth/priv)
: auth - algorithm - (md5,sha1)
: (required only if sec is - auth,auth/priv)
: pass1 - auth password - 8 to 31 chars
: (required only if sec is 'auth,auth/priv')
: priv - algorithm - (des, aes)
: (required only if sec is 'auth/priv')
: pass2 - privacy password - 8 to 31 chars
: (required only if sec is 'auth/priv')
The following parameters must be specified if is not
none :
Authentication type set to md5 or sha1
Authentication password (8 to 31 chars)
The following parameters must be specified if is set to auth/priv :
Privacy algorithm set to des or aes
Privacy password (8 to 31 chars)