Motorola AP-51XX - Manual (Page 379)

8-45
AP51xx>admin(network.wan.nat)> set
Description:
Sets NAT inbound and outbound parameters.
Syntax:
Example:
admin(network.wan.nat)> set type 2 1-to-many
admin(network.wan.nat)> set ip 2 10.1.1.1 (this command is used when NAT is 1-to-1)
admin(network.wan.nat)> show 2
WAN IP Mode : enable
WAN IP Address : 157.235.91.2
NAT Type : 1-to-many
Inbound Mappings : Port Forwarding
unspecified port forwarding mode : enable
unspecified port fwd. ip address : 111.223.222.1
one to many nat mapping
-------------------------------------------------------------------------------
LAN No. WAN IP
-------------------------------------------------------------------------------
1 157.235.91.2
2 10.1.1.1
For an overview of the NAT options available using the applet (GUI), see Configuring Network Address Translation (NAT) Settings on
page 5-21 .
set type Sets the type of NAT translation for WAN address index ( 1 - 8 ) to
(none, 1-to-1, or 1-to-many).
ip Sets NAT IP mapping associated with WAN address to the
specified IP address .
inb Sets inbound IP address for specified index
Sets inbound mode for specified index
outb Sets outbound IP address for specified index
Sets outbound NAT destination .