Motorola AP-51XX - Manual (Page 376)

AP-51xx Access Point Product Reference Guide 8-42
AP51xx>admin(network.wan)> set
Description:
Defines the configuration of the access point WAN port.
Syntax:
Example:
admin(network.wan)>
admin(network.wan)> set dhcp disable
admin(network.wan)> set ipadr 157.169.22.5
admin(network.wan)> set dgw 157.169.22.1
admin(network.wan)> set dns 1 157.169.22.2
admin(network.wan)> set auto-negotiation disable
admin(network.wan)> set speed 10M
admin(network.wan)> set duplex half
admin(network.wan)> set mask 255.255.255.000
admin(network.wan)> set pppoe mode enable
admin(network.wan)> set pppoe type chap
admin(network.wan)> set pppoe user jk
admin(network.wan)> set pppoe passwd @#$goodpassword%$#
admin(network.wan)> set pppoe ka enable
admin(network.wan)> set pppoe idle 600
For an overview of the WAN configuration options available using the applet (GUI), see Configuring WAN Settings on page 5-16 .
set wan enable / disable Enables or disables the access point WAN port.
dhcp enable / disable Enables or disables WAN DHCP Client mode.
ipadr Sets up to 8 (using from 1 to 8 ) IP addresses for the
access point WAN interface.
mask Sets the subnet mask for the access point WAN interface.
dgw Sets the default gateway IP address to .
dns Sets the IP address of one or two DNS servers, where
indicates either the primary (
1 ) or secondary ( 2 ) server, and
is the IP address of the server.
auto-
negotiation enable / disable Enables or disables auto-negotiation for the access point WAN port.
speed Defines the access point WAN port speed as either 10 Mbps or 100
Mbps.
duplex Defines the access port WAN port duplex as either half or full.
pppoe mode enable / disable Enables or disables PPPoE.
user Sets PPPoE user name.
passwd Defines the PPPoE password.
ka enable / disable Enables or disables PPPoE keepalive.
idle Sets PPPoE idle time.
type Sets PPPoE authentication type.