Motorola AP-51XX - Manual (Page 349)

8-15
AP51xx>admin(network.lan)> set
Description:
Sets the LAN parameters for the LAN port.
Syntax:
Example:
admin(network.lan)>
admin(network.lan)> set lan 1 enable
admin(network.lan)> set name 1 engineering
admin(network.lan)> set ethernet-port-lan 1
admin(network.lan)> set timeout 45
admin(network.lan)> set trunking 1 disable
admin(network.lan)> set auto-negotiation disable
admin(network.lan)> set speed 100M
admin(network.lan)> set duplex full
admin(network.lan)> set dns 1 192.168.0.1
admin(network.lan)> set dns 2 192.168.0.2
admin(network.lan)> set wins 1 192.168.0.254
admin(network.lan)> set trunking disable
admin(network.lan)> set username phil
admin(network.lan)> set passwd ea0258c1
set lan Enables or disables the access point LAN interface.
name Defines the LAN name by index.
ethernet-port-lan Defines which LAN (LAN1 or LAN2) is active on the Ethernet port.
timeout Sets the interval (in seconds) the access point uses to terminate its LAN
interface if no activity is detected for the specified interval.
trunking Enables or disables 802.11q Trunking over the access point LAN port.
auto-negotiation Enables or disables auto-negotiation for the access point LAN port.
speed Defines the access point LAN port speed as either 10 Mbps or 100 Mbps.
duplex Defines the access port LAN port duplex as either half or full.
username Specifies the user name for 802.1x port authentication over the LAN
interface.
passwd The 0-32 character password for the username for the 802.1x port.
ip-mode Defines the access point LAN port IP mode.
ipadr Sets the IP address used by the LAN port.
mask Defines the IP address used for access point LAN port network mask.
dgw Sets the Gateway IP address used by the LAN port.
domain Specifies the domain name used by the access point LAN port.
dns Defines the IP address of the primary and secondary DNS servers used by the
LAN port.
wins Defines the IP address of the WINS server used by the LAN port.