Motorola AP-51XX - Manual (Page 510)

AP-51xx Access Point Product Reference Guide 8-176
AP51xx>admin(system.snmp.traps)> set
Description:
Sets SNMP trap parameters.
Syntax:
For information on configuring SNMP traps using the applet (GUI), see Configuring Specific SNMP Traps on page 4-34 .
set mu-assoc enable / disable Enables/disables the MU associated trap.
mu-unassoc enable / disable Enables/disables the MU unassociated trap.
mu-deny-assoc enable / disable Enables/disables the MU association denied trap.
mu-deny-auth enable / disable Enables/disables the MU authentication denied trap.
snmp-auth enable / disable Enables/disables the authentication failure trap.
snmp-acl enable / disable Enables/disables the SNMP ACL violation trap.
port enable / disable Enables/disables the physical port status trap.
dos-attack enable / disable Enables/disables the denial of service trap.
dyndns-update enable / disable Enables/disables dyndns update trap.
interval Sets denial of service trap interval.
cold enable / disable Enables/disables the system cold start trap.
cfg enable / disable Enables/disables a configuration changes trap.
rogue-ap enable / disable Enables/disables a trap when a rogue-ap is detected.
ap-radar enable / disable Enables/disables the AP Radar Detection trap.
wpa-counter enable / disable Enables/disables the WPA counter measure trap.
hotspot-mu-status enable / disable Enables/disables the hotspot mu status trap.
vlan enable / disable Enables/disables VLAN traps.
lan-monitor enable / disable Enables/disables LAN monitor traps.
rate Sets the particular to monitor to given the
indicated . See table below for information on the
possible values for , , and .
min-pkt Sets the minimum number of packets required for rate traps
to fire (
1 - 65535 ).