Motorola AP-51XX User Manual
Page 225
Configuring Access Point Security
6-7
4.
Enable and configure an
Authentication
option if necessary for the target security policy.
5.
Enable and configure an
Encryption
option if necessary for the target security policy.
Manually Pre-Shared
Key / No
Authentication
Select this button to disable authentication. This is the default
value for the
Authentication
field.
Kerberos
Select the
Kerberos
button to display the
Kerberos
Configuration
field within the New Security Policy screen. For
specific information on configuring Kerberos, see
Kerberos Authentication on page 6-8
802.1x EAP
Select the
802.1x EAP
button to display the
802.1x EAP Settings
field within the New Security Policy screen. For specific
information on configuring EAP, see
.
No Encryption
If
No Encryption
is selected, encryption is disabled for the
security policy. If security is not an issue, this setting avoids the
overhead an encryption protocol causes on the
access point
. No
Encryption is the default value for the Encryption field.
WEP 64 (40-bit key)
Select the
WEP 64 (40 bit key)
button to display the
WEP 64
Settings
field within the New Security Policy screen. For specific
information on configuring WEP 64, see
.
WEP 128 (104-bit key) Select the
WEP 128 (104 bit key)
button to display the
WEP 128
Settings
field within the New Security Policy screen. For specific
information on configuring WEP 128, see
.
KeyGuard
Select the
KeyGuard
button to display the
KeyGuard Settings
field within the New Security Policy screen. For specific
information on configuring KeyGuard, see
.
WPA/WPA2 TKIP
Select the
WPA/WPA2 TKIP
button to display the
WPA/TKIP
Settings
field within the New Security Policy screen. For specific
information on configuring WPA/WPA2 TKIP, see
WPA/WPA2 Using TKIP on page 6-21
.