GE Monogram GE Fanuc Automation GFK-1115 - Manual (Page 35)

GFK-1115 Chapter 3 Quick Start 3 - 11
3
Press
↵ ↵
again to open a selection window that contains a list of the available Controllers.
Note
The available Controllers are listed in the form .#, where
is the basic controller model (e.g., C400) and is the
operating system version number (e.g., V1.8).
When you press
↵ ↵
, the controller selection (C400-GEN.#18 in the example above) is confirmed.
Another window appears on the screen from which the display and Keyblock module types can be
configured.
Caution
Both the controller and the display type must be defined when creating a
new project. Once selected, you CAN NOT change them. You should know
which controller and display type will be used before the project creation
process is started.