GE Monogram GE Fanuc Automation GFK-1115 - Manual (Page 169)

GFK-1115 Appendix B Errors/Troubleshooting B - 3
B
Errors During Program Start
PCS cannot be started!
Check that the following conditions are met:
■ PC must contain an 80286 or higher type processor.
■ PC must have at least 640 KB RAM (500 KB must be available). If enough RAM is not
available, remove the necessary memory-resident programs.
PCS Error Message
Fatal Error, PANELWARE requires 1 MB on drive c:
Check that the following condition is met:
■ To start the PCS, the PC must have at least 1 MB hard disk space available.