Fortinet FortiGate 50A - Manual (Page 35)

NAT/Route mode installation Using the setup wizard
FortiGate-50A Installation and Configuration Guide
35
Advanced NAT/Route mode settings
Use Table 13 to gather the information that you need to customize advanced
FortiGate NAT/Route mode settings.
Using the setup wizard
From the web-based manager, you can use the setup wizard to create the initial
configuration of your FortiGate unit. To connect to the web-based manager, see
“Connecting to the web-based manager” on page 19 .
Starting the setup wizard
1 Select Easy Setup Wizard (the middle button in the upper-right corner of the
web-based manager).
2 Use the information that you gathered in Table 12 on page 34 to fill in the wizard fields.
Select the Next button to step through the wizard pages.
3 Confirm your configuration settings and then select Finish and Close.
Reconnecting to the web-based manager
If you used the setup wizard to change the IP address of the internal interface, you
must reconnect to the web-based manager using a new IP address. Browse to https://
followed by the new IP address of the internal interface. Otherwise, you can reconnect
to the web-based manager by browsing to https://192.168.1.99.
You have now completed the initial configuration of your FortiGate unit, and you can
proceed to
“Connecting the FortiGate unit to your networks” on page 37 .
Table 13: Advanced FortiGate NAT/Route mode settings
DHCP server
Starting IP: _____._____._____._____
Ending IP: _____._____._____._____
Netmask: _____._____._____._____
Default Route: _____._____._____._____
DNS IP: _____._____._____._____
The FortiGate unit contains a DHCP server that you can configure to
automatically set the addresses of the computers on your internal network.
Note: If you use the setup wizard to configure internal server settings, the FortiGate unit adds
port forwarding virtual IPs and firewall policies for each server. For each server located on your
internal network the FortiGate unit adds an Ext->Int policy.