Assigning a rip filter list to the incoming filter – Fortinet FortiGate 50A User Manual
Page 118
118
Fortinet Inc.
Adding RIP filters
RIP configuration
3
For Filter Name, type a name for the RIP filter list.
The name can be 15 characters long and can contain upper and lower case letters,
numbers, and special characters. The name cannot contain spaces.
4
Select the Blank Filter check box to create a RIP filter list with no entries, or enter the
information for the first entry on the RIP filter list.
5
Enter the IP address and Mask to create the prefix.
6
For Action, select allow or deny.
7
For Interface, enter the name of the interface to which to apply the entry.
8
Select OK to save the RIP filter list.
To add an entry to a RIP filter list
1
Go to System > RIP > Filter.
2
For the RIP filter list name, select Add Prefix to add an entry to the filter list.
3
Enter the IP address and Mask to create the prefix.
4
For Action, select allow or deny.
5
For Interface, enter the name of the interface to which to apply the entry.
6
Select OK to add the entry to the RIP filter list.
7
Repeat steps
to
to add entries to the RIP filter list.
Assigning a RIP filter list to the neighbors filter
The neighbors filter allows or denies updates from other routers. You can assign a
single RIP filter list to the neighbors filter.
To assign a RIP filter list to the neighbors filter
1
Go to System > RIP > Filter.
2
Add RIP filter lists as required.
3
For Neighbors Filter, select the name of the RIP filter list to assign to the neighbors
filter.
4
Select Apply.
Assigning a RIP filter list to the incoming filter
The incoming filter accepts or rejects routes in an incoming RIP update packet. You
can assign a single RIP filter list to the incoming filter.
To assign a RIP filter list to the incoming filter
1
Go to System > RIP > Filter.
2
Add RIP filter lists as required.
3
For Incoming Routes Filter, select the name of the RIP filter list to assign to the
incoming filter.
4
Select Apply.