Enabling and disabling policies, Disabling policies, Enabling policies – Fortinet FortiGate 50A User Manual
Page 146: Addresses
146
Fortinet Inc.
Addresses
Firewall configuration
Enabling and disabling policies
You can enable and disable policies in the policy list to control whether the policy is
active or not. The FortiGate unit matches enabled policies but does not match
disabled policies.
Disabling policies
Disable a policy to temporarily prevent the firewall from selecting the policy. Disabling
a policy does not stop active communications sessions that have been allowed by the
policy. For information about stopping active communication sessions, see
To disable a policy
1
Go to Firewall > Policy.
2
Select the policy list that contains the policy that you want to disable.
3
Clear the check box of the policy to disable it.
Enabling policies
Enable a policy that has been disabled so that the firewall can match connections with
the policy.
To enable a policy
1
Go to Firewall > Policy.
2
Select the policy list that contains the policy that you want to enable.
3
Select the check box of the policy to enable it.
Addresses
All policies require source and destination addresses. To add addresses to a policy
between two interfaces, you must first add addresses to the address list for each
interface.
You can add, edit, and delete all firewall addresses as required. You can also organize
related addresses into address groups to simplify policy creation.
A firewall address consists of an IP address and a netmask. This information can
represent:
• The address of a subnet (for example, for a class C subnet,
IP address: 192.168.20.0 and Netmask: 255.255.255.0).
• A single IP address (for example, IP Address: 192.168.20.1 and
Netmask: 255.255.255.255)
• All possible IP addresses (represented by IP Address: 0.0.0.0 and Netmask:
0.0.0.0)
Note: IP address: 0.0.0.0 and Netmask: 255.255.255.255 is not a valid firewall address.