Fortinet FortiGate 50A - Manual (Page 204)

204
Fortinet Inc.
Configuring PPTP PPTP and L2TP VPN
2 Add and configure PPTP users.
For information about adding and configuring users, see
“Adding user names and
configuring authentication” on page 172 .
3 Go to User > User Group.
4 Add and configure PPTP user groups.
For information about adding and configuring user groups, see
“Configuring user
groups” on page 177 .
To enable PPTP and specify an address range
1 Go to VPN > PPTP > PPTP Range.
2 Select Enable PPTP.
3 Enter the Starting IP and the Ending IP for the PPTP address range.
4 Select the User Group that you added in “To add users and user groups” on page 203 .
5 Select Apply to enable PPTP through the FortiGate unit.
Figure 29: Example PPTP Range configuration
To add a source address
Add a source address for every address in the PPTP address range.
1 Go to Firewall > Address.
2 Select the interface to which PPTP clients connect.
3 Select New to add an address.
4 Enter the Address Name, IP Address, and NetMask for an address in the PPTP
address range.
5 Select OK to save the source address.
6 Repeat for all addresses in the PPTP address range.