Gradall 534B (9103-1390) Service Manual - Manual (Page 32)

PARKING
Turn off all electrical accessories.
Allow engine to cool at idle speed for a few
minutes and then turn off. Remove ignition
key.
Fill fuel tank to minimize condensation.
Disconnect battery if unit is in an area where
tampering seems possible.
Lock cab (if so equipped).
Position unit in a safe, level parking area.
Apply parking brake and chock wheels.
Retract and lower boom fully.
Clean and inspect machine thoroughly and per-
form all required maintenance.
Coat all cylinder rods with a good grade of
grease or rust preventative.
Park machine in a dry enclosure and remove
batteries.
Prepare engine in accordance with engine
manufacturer’s instructions.
1.
2.
3.
1.
2.
3.
4.
4.
5.
6.
7.
8.
2 6
BOOM EXTENSION IN FEET FROM TIRE TO LOAD CENTER (24 IN FRONT OF FORK FACE).
FIGURES SHOWN ARE STACKING CAPACITY TRUCK LEVEL.
RATED LIFTING CAPACITIES SHOWN ARE WITH MACHINE ON A FIRM. LEVEL SURFACE
WITH UNDAMAGED. PROPERLY INFLATED. HYDROFILLED (CALCIUM CHLORIDE AND WATER)
TIRES. MACHINE SPECIFICATIONS AND STABILITY ARE BASED ON RATED LIFT CAPAC-
ITIES AT SPECIFIC BOOM ANGLES AND BOOM LENGTHS. IF SPECIFICATIONS ARE CRIT-
ICAL. THE PROPOSED APPLICATION SHOULD BE DISCUSSED WITH YOUR DEALER.
DO NOT EXCEED RATED LIFT CAPACITY LOADS. AS UNSTABLE AND DANGEROUS MACHINE
CONDITIONS WILL RESULT. DO NOT TIP THE MACHINE FORWARD TO DETERMINE ALLOW-
ABLE LOAD.
CAPACITY LIMITS FOR THIS UNIT ARE BASED IN ACCORDANCE WITH ANSI 856.6
LEVEL GRADALL HANDLER BEFORE LIFTING ABOVE 4 FT.
CAPACITY CHART: MODEL 534D-8
RATED CAPACITY 2 FT. LOAD CENTER
534D-8
9103-3311
USE WITH
9045-5007 48 CARRIAGE
9045-5008 66 CARRIAGE
STORAGE
Parking brake may not hold machine on a
grade
FOR OTHER ATTACHMENTS CONSULT
FACTORY FOR LOAD RATING.
USE LARGEST NUMBER VISIBLE
FROM CAB TO DETERMINE BOOM
EXTENSION. MATCH WITH BOOM
ANGLE TO DETERMINE ALLOWABLE
LOAD.