Gradall 534B (9103-1390) Service Manual User Manual
Page 156
-31-
Figure 174
Install idler gear bearing locating ring.
Figure 173
Position pump idler gear and bearing on stub shaft.
Figure 172
If fidler shaft bearing locating ring was removed,
install new ring on stub shaft.
Figure 175
Apply a light coat of Dow Corning RTV-03-7069 to O.D. of oil
baffle or counter bore in converter housing. Remove immediate-
ly any excess sealant that could enter the oil circuit.
Figure 176
Assemble new oil baffle oil seal in baffle. Position
oil baffle puller screw holes 15° to 30° either side of
vertical center line. Tap baffle into position until baf-
fle shoulders in converter housing.
Figure 177
Install impeller and hub assembly using caution as
not to damage the oil baffle oil seal.