Gradall 534B (9103-1390) Service Manual - Manual (Page 149)

Figure 135
Install bearing retainer plate, lock plate and idler
gear capscrews. Tighten capscrews 58 to 64 ft. lbs.
torque [78,6 - 86,8 N.m]. Bend lockplate tabs over
capscrew heads to prevent loosening.
Figure 130
Press turbine shaft bearing into position. Install bear-
ing washer and retainer ring. Install new turbine shaft
o i l s e a l i n g r i n g .
Figure 132
Press idler gear bearing on shaft. Install shah and bearing in
idler gear. Position spacer on shaft, press bearing on shaft into
gear. NOTE: See Figure 209 for lock nut type idler shaft
retention.
Figure 131
Spread ears on turbine shaft bearing retainer ring lo-
cated in reaction member support. Tap turbine shaft
into position.
-24-
Figure 133
Position reverse idler and bearing assembly into con-
verter housing. NOTE: Long hub of gear out.
Figure 134
Install reverse idler shaft capscrews and lockwashers.
T i g h t e n 5 8 t o 6 4 f t . l b s . t o r q u e [ 7 8 , 6 - 8 6 , 8 N . m ] .