Gradall 534B (9103-1390) Service Manual - Manual (Page 132)

Figure 33
Separate converter housing from transmission case
assembly. NOTE: Reverse and 2nd clutch will remain
in converter housing.
Figure 36
Using an impact wrench (if available), if not a flange
retainer bar must be used to hole the companion flange
from turning, loosen output flange nut.
Figure 34
Using spreading type snap ring pliers, spread ears
on the reverse front bearing retaining ring.
Figure 35
Holding snap ring open pry reverse and 2nd clutch
assembly from converter housing.
Figure 37
Remove flange nut, washer, “O” ring and flange.
Figure 38
Remove output shaft bearing cap stud nuts and
washers.
-7-