I-View AnyNet-0401Mini Embedded NVR - Manual (Page 82)

82
divisions depend on the different output sources.
Camera number: Represent the number of the camera.
How to swap the cameras for spilt display:
Step 1.
Select the output display from “Output” drop-down menu.
Step 2.
Click the camera from Position display tab.
Step 3.
Move the mouse and click the camera number which would like to swap.
Step 4.
Repeat Step 2 & 3 to swap other cameras’ positions.
Step 5.
Click the camera position and check “Hide video” if needed. Please note if this function is enable,
the background of the grid will become purple.
Step 6.
Click “default” to switch back to factory’s setting if needed.
Step 7.
Click “Save” to finish the setting.
Section 3:
Action to take upon motion detection: The user can enable the pop up video to the output display when
motion is detected. For the setup, please refer to “Schedule setup” from Chapter 4-3-1
Pop up:
Full-page video: Pop up the full screen video when motion is triggered. If there are multi motion
detections at the same time, the latest motion detected video will be shown on the screen.
Split video: Pop up the split screen video when there are multi motion detections at the same time.
Restore video display when trigger stop: Enable to go back the original setting of video display.
Clear border when trigger stop: Remove the surrounding red border around the video channel after
trigger stops.
Section 4:
Video display rotation setup:
Split way: Select full screen or split screen (4/6/8/9/10/13/16 spilt way).
Start from: Select which camera or position to start the rotation.
Duration: Set up the rotation time for the display screen.