I-View AnyNet-0401Mini Embedded NVR - Manual (Page 72)

72
address, you can contact your vendor for optional “dynamic IP service”.
ID code setup:
1.)
Click “ID code setup” from network configuration.
2.)
Enter an “ID code” and click “OK” to register your ID code to an IP dynamic server.
3.)
Enable “Auto connect to dynamic server”.
Video server port: Set up the port number for video streaming remote connections via CMS
(FreeView Pro ). The default port is “1001”.
Event notification port: Set up the port number for pop-up notification to CMS (FreeView Pro
program), the events include Detected motion, Video loss, Sensor triggered, Emergency call, Relay
triggered, Access controller triggered, Storage device fail. Please refer to the NVR setup of FreeView
Pro for event selections. The default port is “5877”.
Event notification password: Set up the password number for pop-up notification to CMS
(FreeView Pro program), the default password is none.
Select default LAN card: The user can un-check “Select default LAN card” if there is another LAN
card for selection.
Maximum TCP/IP users: Set up the maximum users for connecting NVR via IE browser or CMS
(FreeView Pro)
Connection time limit: Set up the duration time for remote connections to NVR.
(For users that are protected by a Firewall); If you are encountering either the error message
“Cannot locate IP address” or “Cannot identify server”, please contact the manufacturer of your
Firewall and ask them how to create a PORT MAPPING. This will create a port in your firewall.
This Port Mapping will enable the remote user to access the Witness ASE/HS/RD series Pro from
the remote site.