I-View AnyNet-0401Mini Embedded NVR - Manual (Page 40)

40
Section 2:
Type: The user can set up recording schedule for “Daily”, “Weekly” or “Special duration”.
Start time & End time: Set up time frame for recording schedule. Here’s a classic sample
recording schedule: “motion triggered recording” from 00:00 to 07:59; “continuous recording”
from 08:00 to 16:59; “motion triggered recording” from 17:00 to 23:59.
You should always set your complete schedule start at 00:00 and end at 23:59. Never overlap
the time entries, such as from 00:00 to 12:00 and from 12:00 to 23:59. It should start from
00:00 to 11:59 and 12:00 to 23:59.
Start date & End date: Select dates for recording in “Special duration”.
Section 3:
Frame Rate: You can set up the recording frame rate for each individual schedule entry.
If you set the recording frame rate higher than what your NVR can physically record, the
recording frame rate will be the maximum your NVR can record.
No Motion Recording: This option is only available under the “motion triggered recording”
mode. When it checked, you can record the videos even if no motion is triggered in case any
incidents. It is advised to set a much lower recording frame rate here to save disk space.
Save pending live videos when motion is triggered: When motion is triggered, the pending
video stream will automatically be saved as a file and subsequently the motion triggered video
stream will be saved into a separate file. This segregation makes your motion triggered playback
videos easier, but you may somewhat inadvertently truncate the beginning of the motion
triggered videos, mostly when you do not enable the pre-recording function or when you set the
motion sensing sensitivity too low. The pre-recording function and motion sensing settings will
be discussed later on in this chapter.
Section 4:
Schedule entries list: This is a list of the set recording schedule entries. To edit one of the listed
entries, simply double click the entries appearing in the list. Once the editing is done, you may
click “Save” button to save your changes or the “Exit” button to discard your changes. To delete
entries, simply highlight the scheduled entry and click “Delete” button.