I-View AnyNet-0401Mini Embedded NVR - Manual (Page 50)

50
Step 1.
Choice “Zone” and “Group” where will announce when NVR is triggered. The detail
setting process of “Zone” and “Group”, please refer to “Public address configuration”
chapter.
Step 2.
Record or choice the existed alarm sound files and setup the interval period between files
and press “Add” icon to save the file. Click the selected files and click “Delete” to
remove the selected alarm sound file.
Step 3.
Enable chime sound if you want to play chime sound before alarm sound.
Step 4.
Adjust the audio volume for play alarm sound.
Step 5.
Click “Save” or “Cancel” icon to finish and exit the setting process.
Trigger output relays: The user can select the output relays from Relay 01 to 13 in
“Controller board” or select the output relays from each IP camera or NC-180AZ PTZ
receiver module.
Play s chime sound
before alarm voice
Adjust alarm voice
volume
List selected zones
and groups
Select announcement
area by zone and
group
Record/Play alarm
sound file
List selected alarm
sound files
Browse /Select the
existed sound file