Extron electronic Ultra Series - Manual (Page 83)

3-39 CrossPoint / MAV Matrix Switchers • Operation
5 . Press and release the Audio button to exit the Audio mode. The Audio button
stops blinking.
N • Pressing the Enter or Preset button also exits Audio mode. Pressing the
Preset button changes to Recall Preset mode.
• There is one audio level setting per input. The audio level setting is shared
by the left and right audio inputs.
• The audio level settings are stored in non-volatile memory. When power is
removed and restored, the audio level settings are retained.
• Exiting Audio mode by pressing the Audio button always returns the
I/O configuration to RGBHV (CrossPoint switchers) or video (MAV Plus
switchers) and audio selected for configuration.
Example 10: Viewing and adjusting an input audio level
In the following example, an audio level is viewed and adjusted. The steps show
the front panel indications that result from your action.
Audio gain and attenuation is displayed differently on different models.
Because of the different gain and attenuation display schemes, the input audio
levels that result from the following example are shown three times: as displayed
on a 32-button switcher, on a 16-button switcher, and on an 8-button switcher. The
32-button displays show the actions that led up to the display. For simplicity, the
16-button and 8-button figures show the attenuation display only, not the actions
that lead up to it.
1 . Press and release the Esc button (figure 3-57).
C O N T R O L
PRESET ENTER ESC VIEW
Press the Esc button to clear all selections.
The button flashes once.
Figure 3-57 — Clear all selections
2 . Press and hold the Audio button for approximately 2 seconds (figure 3-58).
AUDIO AUDIO
Press and hold the Audio button until it blinks.
2 seconds
Figure 3-58 — Select Audio mode